System Memory (RAM) is under utilized. Is there a way to assign the maximum system memory (RAM) for STAAD to speed up the process?

Hello Everyone,

I am working on structure which has lot of plate elements and is normally taking approximately 2.30hrs to finish one complete cycle of analysis and design. While the analysis is running I was observing the utilization of the system memory. I have 32Gb of RAM out of which maximum 3 or 4Gb is utilized for the STAAD Application. My question is, is there any setting that we have to change to let the application use the maximum amount of system memory available and improve the run time of the analysis. I am asking this question because I am not aware if there is an like this for STAAD and I saw similar options in other FEM softwares.

Also, is it possible to check the warp angle of the plates in STAAD.?

Thanks in advance!