Hi,
I have done one STAAD model using (SS6 version). Before refinement of meshing the no of plates created was (24000). During that time i am not getting any error. Buckling and stress analysis were running fine.
But after refining the mesh for finer results, the no of plates increased to (185000). During that time when i run a normal analysis, i am getting an error “SProStaad MFC application has stopped working”.
Then by running buckling analysis using advanced license i am getting an internal error problem.
I have attached both the screenshots for your reference and i have attached both the staad models also.
I also tried to rectify the error using “Memory XXX”, but still i am facing the same issue.
(Please visit the site to view this file)
Kindly give some suggestions. Waiting for the response.