Can anyone answer, please?
1. With two simultaneous members at the same location? I mean Suppose a 1500mm deep Girder, where I want to connect two members (suppose F150X8, W350X5) @ top flange and simultaneously @bottom flange ( Staad represents it as a duplicate member).
2. @ A 1500mm Deep girder Top flange local Z direction loading, (As staad only identifies center line only) I tried offset command, but it shows out of plane loading (Don't know whether it's working or not).
I've attached here trial depiction for better understanding aforementioned queries.
Image may be NSFW.
Clik here to view.
Image may be NSFW.
Clik here to view.
Thanking You,
Ahsanul Kabir.
