I have set up an analysis model with two sets of design code checks for each member, 1) with RATIO = 1.0 for a given LOAD LIST, and 2) with RATIO = 1.33 for a different LOAD LIST.
When I view the design results graphically, it only seems to show the UR based on 2nd set of design parameters. See extract below.
Can I make adjustments in the graphical display so that I can toggle between the two sets of data, i.e. to see UR in each case?
***NEW STEELWORK CODE CHECKS - OPE CASES
LOADLIST9TO18
PARAMETER1
CODEAISCUNIFIED2010
METHODASD
RATIO1MEMB _NEW_STEEL_DESIGN
CHECKCODEMEMB _NEW_STEEL_DESIGN
***NEW STEELWORK CODE CHECKS - STORM CASES
LOADLIST19TO22
PARAMETER2
CODEAISCUNIFIED2010
METHODASD
RATIO 1.33 MEMB _NEW_STEEL_DESIGN
CHECKCODEMEMB _NEW_STEEL_DESIGN