How do you fix an analysis error **ERROR: MINUS AT COLUMN 15 CANNOT BE FOLLOWED BY A BLANK**??? This appears after the DEFINE WIND LOAD line in my input file.
Section of my STAAD input:
210. DEFINE WIND LOAD
*** NOTE: If any floor diaphragm is present in the model Wind Load definition
should be defined after Floor Diaphragm definition. Otherwise wind
load generation may be unsuccessful during analysis.
**ERROR: MINUS AT COLUMN 15 CANNOT BE FOLLOWED BY A BLANK
211. TYPE 1 WIND 1 - PARALLEL LOADS-X
212. <! STAAD PRO GENERATED DATA DO NOT MODIFY !!!
213. ASCE-7-2002:PARAMS 90.000 MPH 5 1 1 0 0.000 FT 0.000 FT 0.000 FT 1 -
214. 1 40.000 FT 12.000 FT 20.000 2.000 0.010 -
215. 0 0 0 0 0.761 1.000 1.000 0.850 0 -
216. 0 0 0 0.873 2.980 -0.550
217. !> END GENERATED DATA BLOCK
218. INT 0.000182915 0.000182915 0.000189329 0.000195242 0.000200738 0.000205882 -
219. 0.000210723 0.000215301 0.000219648 0.000223789 0.000227748 0.000231541 -
220. 0.000235186 0.000238694 0.000242078 HEIG 0 180 203.077 226.154 249.231 -
221. 272.308 295.385 318.461 341.539 364.615 387.692 410.769 433.846 -
222. 456.923 480
**ERROR: MINUS AT COLUMN 15 CANNOT BE FOLLOWED BY A BLANK
223. TYPE 2 WIND 2 - PERP LOADS-Z
224. <! STAAD PRO GENERATED DATA DO NOT MODIFY !!!
225. ASCE-7-2002:PARAMS 90.000 MPH 5 2 1 0 0.000 FT 0.000 FT 0.000 FT 1 -
226. 1 40.000 FT 15.000 FT 20.000 2.000 0.010 -
227. 0 0 1 1 1.044 1.000 1.000 0.850 0 -
228. 0 0 0 0.883 2.980 -0.550
229. !> END GENERATED DATA BLOCK
230. INT 0.000273342 0.000273342 0.000280373 0.000286798 0.000292725 0.000298234 -
231. 0.000303385 0.000308228 0.000312801 0.000317137 0.000321261 0.000325195 -
232. 0.000328959 0.000332567 0.000336035 HEIG 0 180 203.077 226.154 249.231 -
233. 272.308 295.385 318.461 341.539 364.615 387.692 410.769 433.846 -
234. 456.923 480
235. LOAD 1 LOADTYPE DEAD TITLE LOAD CASE 1 - DEAD LOADS
*********** END OF THE STAAD.Pro RUN ***********