Hi there,
Is there currently a way when in RAM SS - Modeler to copy applied surface loads from one floor type to another?
The situation I have is during the progression of a job, quite often a floor layout will change which requires re-importing from RAM Concept into RAM SS to update the slab geometry. I understand this can be done in RAM SS to some degree but I have found importing from Concept to Structural Systems to be the most efficient way of doing so especially when the slab geometry is complex. Once this has been imported and the storey data updated, all of the loads need to be re-applied and drawn in. Often times when the loading areas/line loads are complex shapes, this can be a painful task to repeat again and again especially given DWG files cannot be overlaid and traced but as I understand it they can only be put in using the co-ordinate system.
Could you please advise if there is a process specifically set up for this task or if a more use friendly option is available/coming soon.
Regards
Lewis