After running my analysis, in the staad output viewer I get the following note with regards to beta angle:
**NOTE- IF ANY MEMBER HAS A NON-ZERO BETA ANGLE IN THE CONSTANTS TABLE AND USES THE LOCAL OPTION HERE;
THEN PLEASE Note THAT THIS LOCAL OPTION ALWAYS GENERATES THE OFFSETS BASED ON AN ANGLE OF ZERO
DEGREES (THIS IS A TEMPORARY PSEUDO-BETA THAT IS NOT USED FOR ANY OTHER CALCULATION).
THE BETA IN THE CONSTANTS TABLE WILL STILL BE USED TO DEFINE THE MEMBER LOCAL COORDINATE SYSTEM.
Does it means that beta angle that I have defined for different beams aren't used in any calculations which means Staad does the calculation as though beta angle is 0?