Hello,
I am designing welded moment joints of one of the model according to EN 1993-1-8 (9 single load cases and 13 load combn from 9 load cases) and realized a strange problem.
for 1st joint RAM used all loads correctly for the connection .
When I went to 2nd joint, RAM retained the same values of load but only geometry was correct (column and beam).
also for 2nd joint when I sorted only load combinations from load envelope window, now it retained the load values but not of the corresponding load cases or combinations, but in sequence in which load values for 1st joint were arranged.
i.e., load values of single load cases of 1st joint were attached to load values of 2nd joint load combinations.
It seem that only values were retained and their starting name(load case or combn) was replaced by load combinations.
This is not happening only for any particular file, but in all files.
What is the problem?
Need to sort it as early as possible.
Regards,
Vishal