Hi There,
I have a situation where my columns predominantly span between 2 floors (top of slab on L2 to underside of L3) however in some areas, the levels below do not have slab and the columns are actually spanning between 3 floors. So, if typical columns are 3 meters long, these columns where the there is no slab below would be 6 meters long as this is where the next floor which has slab below is. I believe all of my columns are using the floor to floor height for their length however I need to override that so they span correctly to the next slab below in order to export transfer loads from these columns.
Can you please advise how this is done. I have a previous model where this has been achieved however the person who did this can no longer be contacted. I will upload this model. Thank you in advance.