Dear sir,
A submitted DBR ,which have a highlighted statement "SECTION IS NOT ADEQUATE (*STAAD IS NOT ABLE TO DETAIL AS SECTION WIDTH IS SMALL & DETAILED BY DDC BASED ON R/F)".
kindly consider :- column Section width is 230x 800
Span - 5.49 m
Dia of bar uesd in column section 230x 800 mm :-32mm
It is requested to kindly provide the correct interpretation of above statement. whether it is problem of STAAD software or section width problem.
Kindly communicate at the earliest.
Thanking you in anticipation.
Regards
Santosh Pathak