Hi Guys,
We are trying to input a couple of antennas into a lattice tower model and are having a few issues. Without the antennas the model runs and gives results and outputs. Once the antennas are included (even 1 antenna) the model runs but will not allow any reports or results. The results buttons are greyed out and the reports only show dimensional inputs no results. Once we hit the Build/Load/Analyse button it says "Tower build complete" and then "ANT top below bottom." (horizontal antenna). If we put the tower on a slight angle we get the following " ANT extends beyond tower."
Any help on this would be greatly appreciated.
Thank you
Nicole
