Moving Point Loads With Columns In Concept

Hi,

I have a two way slab I've imported from RAM SS.  It has been detached from the original model and is currently working as a standalone slab analysis model - with the original loads from the columns taken from SS.  These include all of the loads from RAM Frame such as wind loads in both directions and their eccentricities, and seismic with accidental torsion.  All told, there are roughly 20 point loads associated with each column.  Now, I'd like to adjust several of the column locations slightly, however it appears that the point loads don't move with the columns.  

Is there a way to grab the columns and point loads at the same time, and move them simultaneously in Concept?  Trying to move each individually could turn this 5 minute exercise into an hour otherwise. 

Thanks,

Rich